Flame-out

Ok, I’m taking a little break from the steam engine project. After getting the piston and valve made, it became apparent the precision I’m capable of with my Dremel and drill press are not sufficient for the rigors of rapid cyclic motion (as suspected from the start).

While I think more about that, I am working on a wooden arcade game that challenges the player to drop or launch .50 ball bearings down a slope to hit targets. The game will be fully enclosed (to prevent removal of the ball bearings) and will feature a pistol-grip ball launcher/gun as the input mechanism.

Below is a video demonstration of the prototype launcher. The brass receiver tube (the internal magazine) is so closely matched to the .50 balls they occasionally jam in there, so I’m looking into remedies for that. But you can see how the device drops out one ball while retaining the others until the player releases and pulls the trigger again. Ultimately, a supply of balls from within the game itself will replenish that brass tube as the player launches balls, since the tube only holds four.

I’ll post more details about how this works if the project looks ultimately feasible.

One thought on “Flame-out”

Leave a Reply

Your email address will not be published. Required fields are marked *